Cat for a mk2/2.5
Posted: Sat, 13 Nov 2010 5:32 +0000Need a Cat for a mk2/2.5 to join to a Japspeed 4 branch manifold. Dont wanna cut the end flange off. This is the standard cat with short length of pipe on the end.
MX5Ireland
A little corner set aside for MX-5 enthusiasts
http://www.mx5ireland.com/forum/
Cat for a mk2/2.5
Page 1 of 1
Posted: Sat, 13 Nov 2010 5:32 +0000Re: Cat for a mk2/2.5
Posted: Fri, 26 Nov 2010 8:03 +0000humpty bumpty
Re: Cat for a mk2/2.5
Posted: Sat, 27 Nov 2010 11:15 +0000Sat on a wall??? 
Re: Cat for a mk2/2.5
Posted: Tue, 30 Nov 2010 1:19 +0000would a mk1 cat do
Re: Cat for a mk2/2.5
Posted: Wed, 01 Dec 2010 12:46 +0000no, have one on it, well put it back on for nct but the manifold i have is 2 1/4 inch bore to fit a mk2 . Can cut the de-cat i have to fit but dont want the hassle of swapping every 2 years so the 99ish mk2 is what im after.....i think!
Cheers anyways.
Cheers anyways.
Re: Cat for a mk2/2.5
Posted: Mon, 10 Jan 2011 11:44 +0000bump.......
Re: Cat for a mk2/2.5
Posted: Tue, 11 Jan 2011 12:38 +0000Re: Cat for a mk2/2.5
Posted: Tue, 11 Jan 2011 1:45 +0000Teena your a looooooooon 
Re: Cat for a mk2/2.5
Posted: Tue, 11 Jan 2011 11:34 +00001.6 or 1.8?
Re: Cat for a mk2/2.5
Posted: Thu, 13 Jan 2011 11:22 +00001.8 98-01 model i think. Later ones had the cat on the down pipe. 1.6 may do. Its a 2 1/4 inch bore flange.
Re: Cat for a mk2/2.5
Posted: Sat, 22 Jan 2011 9:50 +0000ive a cat from a 98 1.8 jap rs model if thats any use to you.