MX5Ireland

Turbo manifold for NA6 with T25 flange

If you don't get one through here, I had one made by Abe in Artech, absolute gent to deal with + great quality.
http://www.artechfabrication.com/index.php

Steve

Steve wrote:If you don't get one through here, I had one made by Abe in Artech, absolute gent to deal with + great quality.
http://www.artechfabrication.com/index.php

Steve

That's where I got my downpipe too Rhys, he does great work, go for it

if you dont mind me asking.... what kind of money did you pay lads?

think this is any good??

http://www.ebay.com/itm/89-97-Turbo-Man ... 5516wt_954

Worth reading this thread, it links to a very similar (same?) manifold.
http://www.miataturbo.net/showthread.php?t=60200
ETD : http://www.protegegarage.com/600-product-600.html

I got a few quotes at the time for 2 GReddy manifold alternatives :
The ETD manifold was 449usd + 110usd shipping
Artech 325usd + 65usd shipping

Theres cheap cast ones on ebay, i have one on mine, with no issues at all!

You'll have to chop off the flange and put on a t25 one though

ill probably go down the cheaper route and buy ebay spec its gonna be a cheapish build im not looking for crazy power and im only gonna run 7-8 psi.. i can do the fabrication of the t25 flange easy enough or just buy a stainless t25 mani like the one above.. thanks lads.. looking forward to building it.. especially when theres help aroung the place

twail wrote:Theres cheap cast ones on ebay, i have one on mine, with no issues at all!

You'll have to chop off the flange and put on a t25 one though

did you chop the flange off or make a bracket?

I chopped it and welded on a new one.

It does the job fine, and I have a t28 at .8 bar

twail wrote:I chopped it and welded on a new one.

It does the job fine, and I have a t28 at .8 bar

Any chance you have a pic of it after you did so I can see what I must do??