Page 1 of 1

Wanted: Mx5, Mk1, Eunos, 1.6 or 1.8 (For Drifting)

PostPosted: Mon, 05 May 2014 4:57 +0000
by tdi-red di
How are things lads ? Im new here but im on a load of other forums..T.O.C, Autostadt, HondaHeaven ect..

Anyways im planning on building a drift car, so where else to get one but on this :) (Also I know your all car enthusiasts like myself and just for the piece of mind im not here to buy an Mx5 and drive her to the ground, I have plans turbo ect..:) Thats why I came on this)

Anyways....the car doesnt need NCT, Tax, and the body condition is not important...it doesn't even need to be Irish reg :P All I want is a good engine and to be working 100% :) You can P.m me on this as il be on this allot now looking for info and help with my new project :) The names P.J by the way lads..:)

Cheers :)

Re: Wanted: Mx5, Mk1, Eunos, 1.6 or 1.8 (For Drifting)

PostPosted: Mon, 05 May 2014 7:43 +0000
by MX5Spares
We should have something to suit you. 086 8226506.Robert

Re: Wanted: Mx5, Mk1, Eunos, 1.6 or 1.8 (For Drifting)

PostPosted: Tue, 06 May 2014 7:37 +0000
by tdi-red di
Just going to bump this up again :)

Re: Wanted: Mx5, Mk1, Eunos, 1.6 or 1.8 (For Drifting)

PostPosted: Fri, 09 May 2014 10:03 +0000
by Fla
Robert is a first stop for most of us looking for a full car or very reasonably priced parts. I'd be calling him before bumping as he's almost a one stop shop. If you search the forum you will see he is highly thought of.

Best of luck with the drift car.

Re: Wanted: Mx5, Mk1, Eunos, 1.6 or 1.8 (For Drifting)

PostPosted: Sat, 10 May 2014 5:31 +0000
by atmosfar

Re: Wanted: Mx5, Mk1, Eunos, 1.6 or 1.8 (For Drifting)

PostPosted: Tue, 08 Jul 2014 12:44 +0000
by Geoff7t7
Hey man i am probably going to be selling on my 1.6.
Loads of work done and loads of new parts fitted but not cosmetically great, short story is its a std 92 black edition-bilsteins, bbs, nardi, nicer interior,spoiler, air con etc. 180 on the clock-il have to check that tho
Good-Full service, new timing belt/tensioner/waterpump/aux belt,full suspension front and back polybushed, any rust i could get to ground off and sprayed with antigravel (mostly all the underneath looking good now), new rear springs, new drilled and grooved discs, new ebc pads, strut brace, roll bar (not sure if its a 'proper' one tho), new clutch slaver cylinder, new tie-rod ends, good roof to go on, other bits to go in.
Bad-the biggie is it needs a respray or to be wrapped and one panel above where you jack up the car on the rear right has rusted-needs sorting.
Wont be giving it away but any interest?
Cheers