Need help. Are there different size release bearings across the versions? I have a 1.6 with 1.8 flywheel, disc and pressure plate but the release bearing seems too small for the pressure plate diaphragm. I ordered a new Mazda one which was listed for all models but its too small too. The gap in the middle 1.6 diaphragm is 40mm but the one on the 1.8 one I have is around 50mm.
As it sits now, the fingers of the diaphragm are rubbing against the outer edge of the release bearing and not the inner rotating edge as they should be.
Users browsing this forum: No registered users and 3 guests