Does this look right

[Pops]

Finally got around to getting the alignment done just over a week ago but while doing it they found a rear shock leaking pretty bad, so today I replaced the bad shock (thanks robert), however I spotted the camber bolts looking lost in the collar

IMG_1865.JPG

left rear.the one on the right is fairly similar

IMG_1865.JPG

Don't know if it's right or not

[Real Rayzor]

Not sure Pops but I can tell you that mine are the same.

[Pops]

Thanks, probably worried about nothing so. As they say, leave well enough alone.

[MX5Spares]

Hard to tell from the pics but normally the are at 12oclcok position or near enough unless you have lot camber on. or something damaged etc

[Pops]

Hard to tell from the pics but normally the are at 12oclcok position or near enough unless you have lot camber on. or something damaged etc

That's what I thought, when I replaced all the bushings & camber bolts I set them at about 12oclock with the washers in contact with the collar but when the guy was doing the alignment I could see him turning the bolts 180 degrees, totally upside down in the collar. Trying to explain to him that it was wrong wasn't good but got within specs eventually.