|
| |||||
Welding Frame Rails Near Fuel Lines
I failed nct on a small rust hole on the frame rail.
if i run the lines dry while the relay is out and disconnect the lines from the tank and the engine, will i be safe to weld near them ? i cant see why not but anybody else with experience on this might comment?
Re: Welding Frame Rails Near Fuel Lines
How near
The perfection of a Car's beauty is that nothing should be there for beauty's sake.
Re: Welding Frame Rails Near Fuel Lines
Still vapour in the lines.Why not remove the bolts holding the pipe brackets and push away a few inches !! Is it gas or mig welder ??
Re: Welding Frame Rails Near Fuel Lines
its within 4-5 inches anyway. is it easy to drop the lines? its a gas mig welder
Re: Welding Frame Rails Near Fuel Lines
Wouldn't bother me to much but neither does mig welding. Drain the lines, and get them well clear. To be save have extinguishers at hand. Don't do it alone and plan escape route.
The perfection of a Car's beauty is that nothing should be there for beauty's sake.
Re: Welding Frame Rails Near Fuel Lines
Cheers man, i will haha! id say once the lines are clear and have been left for a while to air out it should be ok. ill put a fire blanket around them, just in case!
| ||
Who is onlineUsers browsing this forum: No registered users and 0 guests | ||
FAQ
